Windy-nation TrakMax 40 MPPT Solar Charge Controller Manual de usuario

TrakMax 40 User Manual Revision 1.0 windynation TrakMax 40 MPPT Solar Charge Controller CHC-TRMX-40 User’s Manual Page 1 of 20 windynati

TrakMax 40 User Manual Revision 1.0 3.5 OVERCURRENT PROTECTION Circuit breakers or fuses must be installed in both the battery and solar circuits

TrakMax 40 User Manual Revision 1.0 3.8 COMMUNICATION PORT Network connections allow the TrakMax to communicate with other controllers or compute

TrakMax 40 User Manual Revision 1.0 Battery Type 12 Volt Units 24 Volt Units Lead Acid 0.03 volts (30mv) per degree Celsius 0.06 volts (60mv) pe

TrakMax 40 User Manual Revision 1.0 power, than a hot PV array. When PV voltage is sufficiently high for MPPT to operate, a constant power output

TrakMax 40 User Manual Revision 1.0 4.2.2 Three Stage Charge The TrakMax is configured for a three stage charging process, Bulk, Absorption and F

TrakMax 40 User Manual Revision 1.0 5) Reset the BATTERY TYPE SELECTOR potentiometer to the appropriate setting for the system batteries when the

TrakMax 40 User Manual Revision 1.0 • Equalize: During an equalization cycle, the charging voltage will be held constant at the specified voltage

TrakMax 40 User Manual Revision 1.0 A solid green LED indicates the charging source is functioning properly. A flashing green LED indicates an er

TrakMax 40 User Manual Revision 1.0 5.2.1 Low Voltage Disconnect (LVD) When a DC load is connected, if voltage remains below the Low Voltage Disc

TrakMax 40 User Manual Revision 1.0 automatically when the unit first receives power. PV open circuit voltage must be 12-30VDC for 12VDC battery c

TrakMax 40 User Manual Revision 1.0 Table of Contents 1 Introduction ...

TrakMax 40 User Manual Revision 1.0 batteries and are rated at 80 to 100 amp-hours at 12volts. Many larger systems use L16 batteries, which are us

TrakMax 40 User Manual Revision 1.0 1 INTRODUCTION Windy Nation Inc. (“Windy Nation”) is not assembling the wind unit, installing the solar syst

TrakMax 40 User Manual Revision 1.0 defective Product to repair or replace such Product. If a warranty claim is invalid for any reason, the Custom

TrakMax 40 User Manual Revision 1.0 2 PRODUCT OVERVIEW The TrakMax solar charge controller is a 40 amp 12/24 Volt Maximum Power Point Tracking (M

TrakMax 40 User Manual Revision 1.0 Overload Protection (DC load) 2.0*Inom>5s 1.5*Inom >20s 1.25*Inom temperature controlled Bulk Charge (a

TrakMax 40 User Manual Revision 1.0 3 INSTALLATION  Insure all terminating connections are clean and tight to prevent arcing and overheating. 

TrakMax 40 User Manual Revision 1.0 3.3 GROUNDING The TrakMax is designed to work with grounded electrical systems. In the controller, ground is

TrakMax 40 User Manual Revision 1.0 3) Terminal connectors for DC wiring are located on the lower edge of the circuit board. Once t